NEW ITEM *NOTE* Solvent based products cannot be shipped outside the Continental U.S.
Use to prime model in preparation for painting.
Will fill in small detail and with multiple coats, obscure fine detail. If working with fine detail, use 2782 Super Fine Gray Lacquer Primer. Will sand well both wet and dry, but wet sanding produces finer results. Sand with very fine sandpaper (8802 or 8812 Sanding Films). Coarse sandpaper will scratch the surface. Recoat, once fully dry – 20 minutes under normal conditions. This Primer is a lacquer so it is self dissolving. When applying over paint, always check compatibility before you start. It builds a bonding coat to both the plastic below and paint above. Can be used under all Testor/Model Master/Floquil and PollyScale Acrylics, Enamels or Lacquers. Can be used on plastic, white metal, metal, resin, contour putty and other fillers. Not recommended for highly porous surfaces. Use 28016 Lacquer Thinner. Do not thin with Pactra RC68, RC75, RC95 or Metalizer 1419 Thinners. When airbrushing use High Flow Nozzle 9306C at 20 PSI or less. Keep wet when spraying. Add thinner to stop cob webbing. Be sure to clean surface well with soap and water to remove all grease.